Hinge jig Skeleton two part in case

Length min.=2 5/8" (67 mm)|Length max.=5" (127 mm)|Width min.=1/2" (12.7 mm)|Width max.=1 3/8" (35 mm)|Width max. in 35mm rebate=23 mm |Width max. in 44mm rebate=32 mm|Door sizes possible|Height min.=6' 5" (1956 mm)|Height max.=2100 mm* (6' 10"*)|Thickness min.=5/8" (16 mm)|Thickness max.=2" (51 mm)|Edge stops thickness=6 mm|Weight= 2.9 kg|Jig overall length=1956 mm|Plate thickness=3 mm|Fixed stop max. thickness=25 mm**|* Please note for doors over 2040mm the bottom hinge will be higher than 9" up.|** Max. hinge leaf width 22mm (35mm doors) | The two part Contractor Hinge Jig is a portable fully adjustable block template set designed for recessing hinges in wooden doors & frames using a plunge router.|It is easy to use with minimal setting-up time, completing the job both accurately & quickly.|Used on-site & in joinery shops to increase productivity with excellent results. |Fully adjustable apertures for fire door requirements and renovation work.|Can be used on both inside and outside doors, rebated frames and on maximum 25mm thick fixed stops.|Ideal for fitting a new door in an old frame.|No need for marking out in the conventional way. |Quick & simple to set-up as the hinge is used as the pattern.|Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges.|Use with a light duty plunge router with 1/4 inch collet.|Long reach router cutter required, 12mm diameter with 70mm overall length.|Adjustable edge guides with preset for hinge of 20mm, 25mm and 30mm|Unibase may be needed.|Patent No. GB2490139|T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160. | 3 x Hinge sliding aperture block assemblies|4 x Bradawls (short blade)|1 x 16mm guide bush|1 x Carry case